1g Wireless Switch
9521###
2g Wireless Switch
9522###
Wire free Scene Setter
9712###
Wire free On/Off/Stop Switch
9738
Connect
Features
Deta Connect Wireless Switches can be paired with Deta Connect
Master Dimmers and Deta Connect Sockets to give remote switching of
the device.
Wireless Switches can also be paired with Inline Dimmers and Relays to
solve difficult installations and reduce cabling.
When Wireless Switches are paired with Master Dimmers or Inline
Dimmers, they can turn the light on, off and adjust the light level.
If the Wireless Switches are paired with socket outlets or relays, they
will switch the socket or relay on remotely.
One Wireless Switch can be paired with multiple devices
Wireless switches are battery operated, they can be installed
anywhere – there is no need for cabling or a back box.
It is important to install this product in accordance with the fitting
instructions below. Failure to do so may render your guarantee void.
Installation
Set-up / Linking Products
Wireless Switches and scene setter installation as follows:
Linking a Connect device (Master Dimmer, Socket or Inline device) to a
Connect Wireless Control
1.
Place the Connect device that you wish to control in ‘linking’ mode. For
information on how to do this please refer to the instruction manual
for that specific Connect device.
Master Dimmer
- press and hold both buttons simultaneously – the
blue and amber LED’s will flash alternately to signify linking mode, and
then release them.
Socket Outlet
- press and hold the button until the blue and amber
LED’s will flash alternately to signify linking mode, and then release
them.
2.
Press a button on the device to be “linked” and the Blue LED will flash
quickly to signify that the dimmer is now linked.
The indicator light on the device you are pairing to
will flash to confirm that the Wireless Control is now
linked. This process can be repeated to control
multiple Connect devices from one Wireless Control.
Unlinking the Switch from a Connect device
This will remove
all
wirelessly connected controls
1.
Place the Connect device that you wish to remove in ‘linking’ mode.
For information on how to do this please refer to the instruction
manual for that specific Connect device.
2.
Whilst the Connect device is in Linking Mode, tap a button on the
Wireless Control. The LED light on the target device will flash to
confirm that the Switch and device are unlinked.
Important things to consider
Changing the Battery
Signal Range
•
Reliable range of operation is approximately 15 metres indoors and up
to 100m outdoors using the Connect Link/WiFi-Link. This figure may
vary depending upon the environment; very thick walls, bodies of
water or large metal objects may interfere with radio range.
•
If the distance between the transmitter and receiver is too great to
achieve reliable operation, the Connect
Signal Booster
may be used in
conjunction with this product to increase the range.
A battery will last for typically 2 years.
When the battery voltage is low the
transmission level is low and is
indicated by the blue LED not staying
on as long as normal.
Battery Type: CR2032 3V Lithium Battery
1.
Remove the front plate – see Installation
2.
Remove the Wireless module.
3.
Remove the battery cover and replace the battery, ensuring the
polarity is correct.
4.
Re-assemble in reverse order.
Notes:
Do not recharge
Please dispose of used
batteries responsibly
Keep away from children
Do not swallow (If swallowed, seek medical
advice immediately)
1.
Remove front cover by inserting
screwdriver into slot at bottom and twisting
5.
Reattach the
front plate
3.
Attached the frame to
the back box (if used) or
directly to the wall using
the fixing screws
supplied
4.
Clip Wireless module
into the frame
2.
Remove wireless module, by
using a screwdriver to lever the
module from the frame
