3
4
5
2
1
3
2
1
3
4
2
1
Stopper
Flange
Washer
Gasket
Nut
Washer
Tailpiece
Pivot Rod
& Ball
Pivot nut
Washer
Clip
Strap
Screw
1
2
5
4
7
6
3
Problem
: Faucet leaks from under handle.
Cause
: Bonnet is loose or o-ring on cartridge is
dirty or twisted.
Cause
: Aerator is incorrectly fitted or is dirty
Problem
: Faucet leaks around aerator or an improper
flow pattern.
Action:
1. Unscrew the aerator. Make sure all internal
parts are laying flat.
2. If there is debris, gently flush all parts inside.
3. Reinstall aerator.
Many of these parts come
preassembled. This exploded
diagram is to assist in trouble
shooting.
4
3
3. Remove pivot nut (1). Install horizontal
rod (2) through hole in stopper (3). Hand
tighten pivot nut (1).
4. Attach horizontal rod (1) to strap (2)
using clip (3). Insert lift rod (4) into strap
and tighten screw (5). Pull the lift rod
knob up and down and move the strap
along the horizontal rod to the optimal
location.
2. Apply a small bead of Plumber's
putty
to
underside of flange (1). Insert body (2) into sink.
Screw flange (1) into body (2). Pivot (3) must
face faucet. Pull assembly down firmly and hold
in place. DO NOT TWIST. Tighten nut,
washer & gasket (4), clean off excess Plumber's
putty .
1
2
1. Remove stopper (1) and flange (2). Screw
nut (3) all the way down. Push washer (4) and
gasket (5) down. Remove tailpiece (6) from
body (7), add Teflon tape, replace tailpiece.
TROUBLE SHOOTING
POP-UP (OPTIONAL) INSTALLATION PROCEDURE
Body
Action:
1. Move handle to OFF position. Remove index
and unscrew the screw on Connector. Then
remove the handle and handle seat.
2.Tighten the bonnet by turning it clockwise. Move
the cartridge stem to the ON position. The leak
should stop around the cartridge stem.
3. If the leak does not stop, shut off the water supply.
Remove the bonnet by turning it counter clockwise.
Lift cartridge off body and remove cartridge seal.
Clean cartridge ports and cartridge seal. Place
cartridge seal into cartridge ports or replace if
necessary.
4. Replace the cartridge making sure the wings fit
well into the cuts in the faucet body. Tightly screw
the bonnet onto the faucet body.
5. Reinstall the handle.
Index
Cartridge
Bonnet
Handle Seat
Handle
Connector
screw
Aerator
