4C
4B
4A
5A
5B
5C
OR
1.Shut off water supply. Remove old faucet, taking care not to damage existing water lines. Clean surface in
preparation for new faucet.
4.Align tabs (4A) and tabs (4B) on quick
connects (4C). Push quick connects firmly
upward and snap onto receiving tube tab.
Pull down moderately to ensure each
connection has been made.
5.Make connections to water lines. Use 1/2"
IPS faucet connections (5A) or use coupling
nuts (5C) (not
included) with
3/8"O.D.ball-nose risers (5B). Use wrenches
to tighten connections. Do not overtighten.
6
4
5
6.Important: After installation is completed,
remove aerator. Turn on water supply and
allow both hot and cold water to run for at
least one minute each. While water is
running, check for leaks. Replace aerator.
3.Slide hot and cold end valves through sink
mounting holes. Make sure long tubes are
installed away from the spout. Handles
should point out when in off position. The
hot side handle is indicated by a tag with red
printing. Hot side handle should be on the
left. Secure end valves with metal washers
and threaded brackets. Hand tighten
brackets onto shank. Lock brackets into
position by tightening screws.
2.Place flange on bottom of spout body.
Place spout through mounting hole in sink.
Secure spout with washer and nut.
3
2
1-800-558-8700
Mequon, WI 53092
Design House is a registered
brand of DHI Corp.
TWO HANDLE
LAVATORY FAUCET
Models 523332, 523316,523324
silicon sealer
flashlight
faucet supply tubes
basin wrench
Teflon tape
(2) crescent wrenches
Your new Design House faucet will give you years of trouble free performance. Thank you for
choosing our product for your home.
Please read all of these instructions carefully before installing your new faucet.
Helpful tools to install this faucet:
IMPORTANT POINTS
When installing your new faucet, hand tighten the connector nuts, then use one wrench to
anchor the fitting and a second wrench to tighten the nut one additional turn. Connections that
are too tight will reduce the integrity of the system.
Wrap threaded connections (except aerator thread in spout or where o-ring or rubber sealant
are present) with Teflon tape available from your local hardware or plumbing supply store.
Always wrap in a clockwise direction.
SAFETY TIPS
ALWAYS
protect your eyes with safety glasses.
CONSUMER PROTECTION WARNING
Under the Safe Drinking Water Act, the U.S. Environmental Protection Agency restricts the
amount of lead used in brass and solder. Your new faucet is made in strict compliance with
all government standards. The materials used in the manufacture of this faucet are of industry
standard quality and are similar to other plumbing products having brass fittings.
To reduce the amount of lead in your drinking water, allow the water to run for a moment before
filling your glass and remember to always use cold water for drinking purposes.
Your new Design House faucet is designed to give you years of trouble free performance. Keep it looking
new by cleaning it periodically with a soft cloth. Avoid abrasive cleaners, steel wool and harsh chemicals
that will dull the finish and void your warranty
Brass finishes are polished, then protected with a lacquer coating to help prevent tarnishing. Clean these
surfaces only with a damp, soft cloth.
INSTALLATION PROCEDURE
MAINTENANCE
