36
2.2.3.4 Temporary Occupancy
This screen allows the unit to be set to the occupied mode for a preset amount
of time. Press the
ENTER
key and enter the hours you would like the unit
to be temporarily in the occupied mode. Press the
ENTER
key again and
enter the minutes you would like the unit to be temporarily in the occupied
mode. Press the
ENTER
key again and the cursor will begin blinking over
the “Press Prg to set” message. Pressing the
Prg
key will override the
schedule and allow the unit to be temporarily occupied. The screen will now
show “Override On.” To clear this occupied override, set the hours and
minutes to zero and press the
Prg
key. The screen will now show
“Override Off.”
Figure 39
To return to the MAIN MENU, press the
Esc
key.
2.2.3.4.1 Temporary Overrides
If TEMPORARY OVERRIDES is shown in the Occupancy Schedule
menu instead of TEMPORARY OCCUPANCY it is because the Event
Mode or the Purge mode or both have been enabled. In this case, a
menu screen similar to Figure 40 will be shown. Selecting any of
these options will allow an override to be active for that mode. The
override of the event or purge modes work in the same manner as
detailed in section 2.2.3.4 for the temporary occupancy.
Desert Aire - CM3510 Manual
Summary of Contents for CM3510 Series
