TB-3033
Page 2 of 5
© 2011 DESCO INDUSTRIES INC.
Employee Owned
Features and Components
GUN AND HOSE
E. Disposable Filter Release / Lock Button:
Push down
to release the disposable filter and hose assembly from
the console. This button should also click when properly
attaching the disposable filter and hose assembly to the
console.
F. Disposable Filter:
Filters particles, oil and moisture from
the incoming air supply.
Figure 2: Gun and hose features and components
A
C
D
E
B
Figure 3: Console features and components
A
B
C
D
E
F
A. Hanging Clip:
Use to hang the gun on an apparatus.
May also be used with the included S-Hook.
B. Status LED:
Illuminates when the trigger is held down.
Indicates when the gun is outputting ionized air.
C. Nozzle:
Outputs ionized air when the trigger is held
down.
D. Trigger:
Hold down to output ionized air.
E. Filter Connection:
Hold down the metal tab to attach or
release the disposable filter.
CONSOLE
A. Power LED:
Illuminates when the power is turned ON.
B. Power Switch:
Turns the power ON or OFF.
C. Foot Switch Jack:
Foot Switch Jack: Connect the
optional foot switch item #
19592
here. See Figure 4.
D. Supply Connection:
Use with the quick coupling to
connect to an air supply.
DESCO WEST
- 3651 Walnut Avenue, Chino, CA 91710 • (909) 627-8178 • Fax (909) 627-7449
DESCO EAST
- One Colgate Way, Canton, MA 02021-1407 • (781) 821-8370 • Fax (781) 575-0172 • Website:
Desco.com
Figure 4:
19592
optional foot switch should be
connected to the ion gun console Letter C in Figure 3
Installation
COMPRESSED GAS REQUIREMENTS
NOTE: Failure to use clean dry air or nitrogen may result
in damage to the Chargebuster Ion Gun that is not covered
under the Limited Warranty.
The compressed gas supply must be clean dry air or
nitrogen supplied by a delivery system that utilizes a
refrigerated dryer or equivalent water removal to achieve a
limit of about 550 ppm water vapor at 35°F (1.66°C) Dew
Point. To prevent particles from entering the console, a 2
micron coalescing filter or better is recommended upstream
of the gun console. Note that the filter in the console
collects small residual particles and aerosols and does not
act as a primary filter. The console filter is rated at 0.01
micron for particulates and is effective down to 0.008 micron
for aerosols.
An adequate filter that can be recommended for the inlet
of the Chargebuster Ion Gun would be a Finite Filter Grade
10 Media Specification. This provides a 95% coalescing
efficiency for aerosols with a 0.7 micron (and greater)
particle retention. This removes gross amounts of particles,
water and/or oil and aerosols.
A Grade 6 Media provides 99.98% efficiency when almost
total removal of liquid aerosols and particles are required in
all pressure ranges down to 0.01 microns. Fine filters need
to be changed more often.
MOUNTING THE CONSOLE
Plug one end of the included 10’ cable into the jack on the
back of the console. Plug the other end of the cable into the
unplugged Wall Transformer.
