15/15
At use
Possible problem
Possible cause
Solution
The mat does not
deploy
The roll belts are still fastened
Remove the roll belts
The mats is blocked (Mobi-Roll’N
Stow™ is under the mat)
Lift the Mobi-roll ‘N Stow and place
it about 6.5’ / 2m backwards on the
mat.
While one operator maintains the
deployed mat, the other operator
unrolls what remains of the mat going
backwards.
When deployment is finished, free the
mat and correct its position by hand.
The mat is not long
enough
Recover the mat and shift the end to
gain the missing length.
Deploy the mat completely, free the
mat from Mobi-Roll’N Stow™ .
Pull the mat after checking that it is
not anchored to the ground.
The mat does not
roll up during the first
round
Mat threshold bar prevents winding
Push the Mobi-Roll’N Stow™ by lowe-
ring its handle to the floor
The X-connector is badly reintro-
duced in the C profile of the mat (it is
not aligned).
Put the X-connector in alignment
with the C profile.
Reposition the mini I-connector in
the X-connector.
One of the mini I-connector parts
has not been positioned.
Position the Mobi-Roll’N Stow™ at a
distance of about 1m before the end
of the mat, then perform the dead
turn by bringing the mat over the
cross bar up to the inside wheels to
make the connection with the mini
I-connector.
The mat was not correctly positioned The Mobi-Roll’N Stow™ is not cente-
red on the mat
