123673-01A
2
www.desatech.com
Header #4
Header
Assembly
Block
Figure 1 - Installing Header
1
1
/
4
"
Screws
Left Leg
Assembly #3
Right Leg
Assembly #2
Figure 4 - Installing mantel Base
Base #1
1
1
/
4
"
Screws
ASSEmbLING mANTEL
Important:
more than one person is required to lift
assembled mantel. Lift mantel by leg assemblies. Lifting
by header or mantel top could damage mantel.
Use the following illustrations to assemble mantel. Use only
screws provided.
Figure 3 - Installing top
1
1
/
4
"
Screws
Mantel
Top #5
Assembly
Blocks
IMPORTANT:
Make sure heat reflector strip is flush against
header and spacers are on bottom side. Heat strip should
NOT be flush with leg side but should have 1" clearance on
both ends.
Figure 2 - Installing Heat Strip
IMPORTANT
: Align mantel top left to right before installing.
Back of mantel leg must be flush with back of mantel top
before installation.
IMPORTANT
: Align mantel left to right on base before install-
ing. Mantel legs must be flush with back of mantel base before
installation. Use a tape measure to insure accuracy.
Flush
1
1
/
4
" Screw
Heat Reflector
Strip #6
Header #4
Right Leg
Assembly #2
Left Leg
Assembly #3
