111253-01E
For more information, visit www.desatech.com
For more information, visit www.desatech.com
25
25
OPERATING FIREPLACE
OPERATING FIREPLACE
For Your Safety Read Before Lighting
Lighting Instructions
To Turn Off Gas To Appliance
Optional Remote Operation
Figure 49 - Turning Equipment Shutoff Valve to the OFF Position
TO TURN OFF GAS
TO APPLIANCE
1
.
Turn off the wall switch.
2.
Turn off all electric power to the appliance if service is to
be performed.
3.
Open lower louver panel.
4.
Remove front hearth brick and control access panel.
5.
Turn equipment shutoff valve clockwise
Clockwise
to OFF.
Do not force.
6.
Close lower louver panel.
Figure 50 - Pilot
Sensing Rod
Pilot Burner
Ignitor
LIGHTING
INSTRUCTIONS
1.
STOP! Read the safety information, above.
2.
Turn off all electric power to the appliance.
3.
Turn wall switch to the OFF position.
4.
Open lower louver panel.
5.
Turn equipment shutoff valve clockwise
Clockwise
to the OFF
position (see Figure 49). Do not force.
6.
Wait five (5) minutes to clear out any gas. Then smell for
gas, including near the floor. If you smell gas, STOP! Fol-
low “B” in the safety information above. If you don’t smell
gas, go to the next step.
7.
Turn equipment shutoff valve counterclockwise
C-clockwise
to the ON position. Do not force.
8.
Close lower louver panel.
9.
Turn on all electric power to the appliance.
10. Turn the wall switch to the ON position.
NOTICE: During initial operation of new heater, burn-
ing logs will give off a paper-burning smell. Orange
flame will also be present. Open damper or window to
vent smell. This will only last a few hours.
11. Visually locate the pilot. The ignitor should begin to spark and
the main burner should ignite once flame appears at pilot.
• If lighting the appliance for the first time each season, it
may take several attempts before the supply gas can reach
the pilot and main burners.
• If the appliance will not stay lit after several attempts,
follow the instructions
To Turn Off Gas To Appliance
, be-
low, and call your service technician or gas supplier.
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing prop-
erty damage, personal injury or loss of life.
A. This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot by
hand.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch.
• Do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire de-
partment.
C. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been under water.
Equipment Shutoff Valve
OPTIONAL REMOTE
OPERATION
Note:
The WRC receiver and hand-held remote control kit
must be purchased separately (see
Accessories
, page 37). Follow
installation instructions on page 24.
1.
Turn equipment shutoff valve to ON position. You can now turn
the burner on and off with the hand-held remote control unit.
IMPORTANT:
Be sure to press the ON/OFF buttons on the
hand-held remote control unit for up to 3 seconds to assure
proper operation.
2.
Press the ON/OFF button to turn the burner on and off.
Adjustment
Screw
