![background image](http://html.mh-extra.com/html/desa/vsgf33nrc/vsgf33nrc_owners-operation-and-installation-manual_2486140008.webp)
www.desatech.com
119304-01A
8
INSTALLATION
NOTICE: This heater is intended
for use as supplemental heat.
Use this heater along with your
primary heating system. Do not
install this heater as your pri
-
mary heat source. If you have a
central heating system, you may
run system’s circulating blower
while using heater. This will help
circulate the heat throughout the
house. In the event of a power
outage, you can use this heater
as your primary heat source.
WARNING: A qualified ser
-
vice person must install fire
-
place. Follow all local codes.
WARNING: Never install the
fireplace
• in a bedroom or bathroom
• in a recreational vehicle
• where curtains, furniture,
clothing, or other flammable
objects are less than 42" from
the front, top, or sides of the
heater
• in high traffic areas
• in windy or drafty areas
CAUTION: This fireplace cre
-
ates warm air currents. These
currents move heat to wall sur-
faces next to fireplace. Installing
fireplace next to vinyl or cloth
wall coverings or operating
heater where impurities (such
as, but not limited, to tobacco
smoke, aromatic candles, clean-
ing fluids, oil or kerosene lamps,
etc.) in the air exist, may discolor
walls or cause odors.
Note:
Your fireplace is designed to be used in zero
clearance installations. Wall or framing material
can be placed directly against any exterior surface
on the rear, sides, or top of your fireplace, except
where standoff spacers are integrally attached. If
standoff spacers are attached to your fireplace,
these spacers can be placed directly against wall
or framing materials.
Use the dimensions shown for rough openings to
create the easiest installation. See
Built-In Fire-
place Installation,
page 11.
IMPORTANT:
Vent-free heaters add moisture to
the air. Although this is beneficial, installing fire
-
place in rooms without enough ventilation air may
cause mildew to form from too much moisture. See
Air for Combustion and Ventilation,
page 5.
IMPORTANT:
Make sure the fireplace is level. If
fireplace is not level, log set will not work properly.
CHECK GAS TYPE
Use the correct gas type (natural or propane/LP)
for your fireplace. If your gas supply is not cor
-
rect, do not install fireplace. Call dealer where you
bought fireplace for proper type fireplace.
This appliance is only for use
with the type of gas indicated on
the rating plate. This appliance
is not convertible for use with
other gases.
WARNING: This appliance
is equipped for natural or pro
-
pane/LP gas. Field conversion
is not permitted.
ELECTRICAL HOOKUP
(Models GA3750 Series and GA3650T
Series Blower Accessories, and GA3555
Internal Duplex Kit)
This fireplace accepts a blower assembly with an
electrical cord. The electrical cord is five feet in length.
You must locate fireplace within reach of a 120 volt
grounded electrical outlet. If not, you must install an
electrical outlet within reach of fireplace power cord.
The GA3555 outlet accessory may be used for built-in
applications with blower accessory installed.
INSTALLING HOOD
Install hood to rail already installed in fireplace as
shown in Figure 5, page 9. Use 3 Phillips screws
provided.