www.desatech.com
108794-01F
17
FIrePlACe INstAllAtIoN
Continued
Figure 31 - Installing Optional Glass
Door
Spring.Clip
Insert Pin Into Spring Clip
Insert Bottom Pivot Pin Into
Pivot.Plate.and.Swing.Door.
Into Vertical Position
Pivot.Plate
Slide.Top.
Pin.Into.
Door.Track
4. Tilt glass assembly fully vertical until outer
pivot pin snaps into mounting hole in up
-
per spring clip (see Figure 31).
5. Once top and bottom pins are secured,
unfold door into closed position.
6. Repeat process for opposite door as
-
sembly.
7. To adjust doors, slide them partially open.
Using a screwdriver, loosen hold-down
screws in spring clip and pivot plate (see
Figure 32).
8. Close both doors until evenly joined at
middle and note gap at outer edges of
the.face.
9.. Reopen.one.door.at.a.time.and.retighten.
upper and lower hold-down screws.
10. Repeat process until both doors are even
-
ly joined, spaced and working freely.
CAUTION: The glass pan-
els become very hot while the
appliance is operating. Do not
attempt to adjust or clean the
glass doors until the appliance
has fully cooled.
Removing Glass Doors for Replacement
or Cleaning
1. Partially open door and press up on upper
spring clip with a screw driver until outer
top pivot pin is free of clip.
2. Fully fold frame assembly and slide upper
edge towards center of firebox opening
until guide pins are free of frame rail (see
Figure 33).
CAUTION: Always operate
the appliance with the doors ei-
ther fully opened or fully closed.
Operating the appliance with
the doors partially open can re-
sult in improper venting of flue
products.
Figure 32 - Adjusting Glass Doors
Spring.
Clip
Hold-Down.
Screw
Side.
Front.
Face
Partially.
Opened.
Door
Figure 33 - Removing Glass Doors
Spring.Clip
Depress
Spring.Clip.
to Release
Pivot.Pin
Remove Bottom Pin
From.Pivot.Plate.While.
Sliding.Door.Out.of.
Upper.Track
Pivot.Plate
Fold Bi-Fold
Door.After.
Releasing
Spring.Clip.
and.Slide.
Door.Out.of.
Upper.Track
