114418-01A
For more information, visit www.desatech.com
For more information, visit www.desatech.com
4
Figure 8 - Removing Mounting Screws, Pressure Regulator
Tower, and Diaphragm/Spring Components
HI
LO
O
FF
PIL
O T
O
N
Mounting Screws
Pressure
Regulator Tower
Diaphragm/Spring
Components
GAS CONTROL VALVE CONVERSION
Convert the gas control valve by swapping out the valve regulator
portion of the gas valve.
1.
Using a Torx T20 or slotted screwdriver, remove and discard
the three mounting screws, pressure regulator tower, and dia-
phragm/spring components (see Figure 8).
2.
Insure that the rubber gasket is properly positioned on the new
pressure regulator assembly. Install the LP pressure regulator
assembly to the valve using the new mounting screws sup-
plied with the kit. Tighten screws securely (approximately 25
in-lbs.) (see Figure 9).
3.
Install the identification label enclosed with the gas valve regula-
tor to the valve body where it can easily be seen (see Figure 9).
HI
LO
O
FF
PIL
OT
O
N
Figure 9 - Installing Pressure Regulator Assembly
Mounting Screws
Rubber
Gasket
Identification Label