www.desatech.com
123168-01C
16
INSTALLATION
Continued
INSTALLING LOGS
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
CAUTION: After installa-
tion and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With the heater set to High, check
to see if flames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact-
ing logs will create soot.
It is very important to install these logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater.
1. Place rear log (#1) onto base. Holes in
bottom of log must seat over pins on base
as shown in Figure 17.
2. Place middle log (#2) onto base. Holes in
bottom of log must seat over pins on base
as shown in Figure 17.
Figure 17 - Installing Rear and Middle
Logs
Figure 18 - Installing Front Log
Figure 19 - Installing Left and Right Logs
3. Place front log (#3) onto grate as shown
in Figure 18.
4. Place left top log (#4) as shown in Figure
19. Match square peg on top of rear log
(#1) with square hole on bottom of left top
log (#4). Match round peg on top of middle
log (#2) with round hole on bottom of left
top log (#4).
5. Place right top log (#5) as shown in Figure
19. Match square peg on top of rear log
(#1) with square hole on bottom of right
top log (#5). Match round peg on top of
front log (#3) with round hole on bottom
of right top log (#5).
Front Log
Grate
Burner
Middle Log
Rear Log
Pin for
Hole in
Bottom
of Log
Left Top
Log
Square Peg
on Rear Log
Round
Peg on
Middle
Log
Right
Top
Log
Round
Peg on
Front Log