![background image](http://html1.mh-extra.com/html/desa/gwrn18/gwrn18_safety-information-and-installation-manual_2485898012.webp)
107885-01D
For more information, visit www.desatech.com
For more information, visit www.desatech.com
12
INSTALLATION
Continued
INSTALLATION
Checking Gas Connections (Cont.)
Figure 17 - Checking Gas Joints for Propane/LP Gas
Figure 15 - Equipment Shutoff Valve
Equipment
Shutoff
Valve
Propane/LP
Supply
Tank
Thermostat
Gas Valve
ON
POSIT
O
PO
Open
Closed
Equipment
Shutoff
Valve
Figure 16 - Checking Gas Joints for Natural Gas
Equipment
Shutoff
Valve
Gas
Meter
Thermostat
Gas Valve
Test Pressures Equal To or Less Than 1/2 PSIG (3.5 kPa)
1.
Close equipment shutoff valve (see Figure 15).
2.
Pressurize supply piping system by either opening propane/LP
supply tank valve for propane/LP gas or opening main gas valve
located on or near gas meter for natural gas, or using com-
pressed air.
3.
Check all joints from gas meter for natural gas (see Figure 16)
or propane/LP supply tank for propane/LP gas, to equipment
shutoff valve (see Figure 17). Apply a noncorrosive leak de-
tection fluid to all joints. Bubbles forming show a leak.
4.
Correct all leaks at once.
Pressure Testing Heater Gas Connections
1.
Open equipment shutoff valve (see Figure 15).
2.
For natural gas open main gas valve located on or near gas
meter. For propane/LP gas open propane/LP supply tank valve.
3.
Make sure control knob of heater is in the OFF position.
4.
Check all joints from equipment shutoff valve to thermostat
gas valve (see Figure 16 or 17). Apply a noncorrosive leak
detection fluid to all joints. Bubbles forming show a leak.
5.
Correct all leaks at once.
6.
Light heater (see Operating Heater, page 13). Check all other
internal joints for leaks.
7.
Turn off heater (see To Turn Off Gas to Appliance, page 14 or
16 depending on your model).
8.
Replace front panel.