2
103369
PRESTIGE MANTEL KIT
GMC26F, GMC27U,
AND
GMC28F
Left Side
TOP VIEW
Header
1 1⁄4" Screw
Left Side
Right Side
Header
Figure 1 - Installing Header
Mounting Block
ASSEMBLING MANTEL
1.
Slide header between mantel right and
left sides. Push sides together to ensure
a tight fit.
2.
Locate predrilled holes in header (see
Figure 2). Attach to sides with four
1 1/4" screws. The top of header must
be flush with top of legs.
Figure 2 - Attaching Header
3.
Turn top and side assembly upside
down. Place assembly inside top. Flush
rear of sides with back of top. Make
sure the notches in the sides fit over the
back trim of the top (see Figure 3).
4.
Locate predrilled holes in mounting
blocks located on back of mantel front
panel and sides (see Figure 3). Attach
mantel assembly to top with one 1 1/4"
screw in each block.
Figure 3 - Securing Top to Sides
Mounting
Blocks
Back Trim
1 1/4" Screw
Notch
Top
INSTALLATION
Note:
To flush mantel to wall, remove the
portion of the baseboard behind the mantel.
1.
Set heater on wooden base. Line up
back of heater flush with back of base.
2.
Line up holes in mounting block with
holes in heater. Attach mounting block
with two 1 1/4" screws (see Figure 4).
Repeat for other side.
Mounting Block
Screws
Hole in Back
of Heater
Side of
Heater
Figure 4 - Securing Heater with Mounting
Block
3.
Set heater and base assembly in desired
location.
4.
Using the same screws you used to
attach the brass trim, attach hardware
brackets to top front corners of heater
through the brass trim (see Figure 5).
Brass Screw
Hardware Brackets
Figure 5 - Attaching Header Brackets to
Heater
Brass Trim
