![background image](http://html1.mh-extra.com/html/desa/comfort-glow-cgfb32cb/comfort-glow-cgfb32cb_safety-information-and-installation-manual_2486322009.webp)
www.desatech.com
116548-01H
9
2. Lift and remove firebox bottom (see
Figure 10).
3. If installing GA3750A blower accessory,
see
Installing Blower Accessory,
page 8.
4. Route flexible gas line from equipment
shutoff valve into firebox through side.
Notice: most building codes
do not permit concealed gas
connections. a flexible gas line
is recommended to allow acces-
sibility from the firebox. the flex
-
ible gas supply line connection
to the equipment shutoff valve
should be accessible.
5. Attach gas log heater base to firebox bot-
tom with four screws included with base
(see
Installing Heater Base Assembly
in
log set owner’s manual).
6. Replace firebox bottom and secure with
screws.
INSTALLATION
Continued
Figure 9 - Routing Blower Accessory
Power Cord for Built-In Installation
Screw
Blower Power Cord
Blower
Support Bracket
Cables From
Electrical Source
Duplex
Outlet
operating Blower
Light your gas appliance with the blower off.
After about 15 minutes, turn the blower on
to deliver heated air at the top louvers. The
blower features a variable control which al-
lows you to select the speed you desire.
Note: Periodically check the louvers of the
firebox and remove any dust, dirt or other
obstructions.
INstAllING loG heAteR IN
fireBox
cautioN: do not pick up log
base assembly by burners. this
could damage burners. only
handle base by grates.
cAutIoN: do not remove the
data plates attached to the heater
base assembly. the data plates
contain important warranty and
safety information.
1. Remove 4 screws holding firebox bottom
in place.
Figure 10 - Removing Firebox Bottom
5. Connect wires from the electrical box to
duplex outlet. Match wire colors to those
indicated on duplex outlet. Be sure to
connect ground wire.
6. Replace duplex outlet with screw.
7. Plug blower power cord into duplex outlet.
8. Replace bottom of firebox.
AsseMBlING ANd AttAchING
oPtIoNAl BRAss tRIM
Note: The following instructions show assem-
bling and attaching brass trim to fireplace.
1. Remove packaging from three pieces of
brass trim.
2. Locate four brass screws, two adjusting
plates with set screws and two shims in
the hardware packet.
3. Align shim under adjusting plate as shown
in Figure 11, page 10.
4. Slide one end of adjusting plate/shim in
slot on mitered edge of top brass trim (see
Figure 11, page 10).
5. Slide other end of adjusting plate/shim
in slot on mitered edge of side brass trim
(see Figure 11, page 10).
f i r e - p a r t s . c o m