![background image](http://html1.mh-extra.com/html/desa/cgx3924nr/cgx3924nr_owners-operation-and-installation-manual_2485783026.webp)
108114
For more information, visit www.desatech.com
For more information, visit www.desatech.com
26
TROUBLESHOOTING
TROUBLESHOOTING
Continued
OBSERVED PROBLEM
One or both burners do not light after ODS/
pilot is lit
Delayed ignition of one or both burners
Burner backfiring during combustion
Yellow flame in front burner during burner
combustion
Slight smoke or odor during initial operation
Heater produces a whistling noise when
burners are lit
White powder residue forming within burner
box or on adjacent walls or furniture
Moisture/condensation noticed on windows
REMEDY
1. Contact local natural or propane/LP gas
company
2. Clean burner(s) (see C
leaning and Mainte-
nance
, page 24) or replace burner orifice(s)
3. Contact qualified service person
4. Replace burner orifice(s)
5. Reconnect leads (see
Wiring Diagram,
page 29)
6. Replace battery in transmitter and
receiver
1. Contact local natural or propane/LP gas
company
2. Clean burner(s) (see
Cleaning and Main-
tenance
, page 24) or replace burner
orifice(s)
3. Contact qualified service person
1. Clean burner (see
Cleaning and Mainte-
nance
, page 24) or replace burner orifice
2. Replace damaged burner
3. Replace gas regulator
1. Check burner(s) for dirt and debris. If
found, clean burner(s) (see
Cleaning and
Maintenance
, page 24)
2. Replace gas regulator
1. Problem will stop after a few hours of
operation
1. Turn control knob to LO position and
let warm up for a minute
2. Operate burners until air is removed
from line. Have gas line checked by lo-
cal natural or propane/LP gas company
3. Observe minimum installation clear-
ances (see pages 8 through 10)
4. Clean burners (see
Cleaning and Main-
tenance
, page 24)) or replace burner
orifice(s)
1. Turn heater off when using furniture
polish, wax, carpet cleaners, or similar
products
1. Refer to Air for
Combustion and Venti-
lation
requirements (page 5)
POSSIBLE CAUSE
1. Inlet gas pressure is too low
2. Burner orifice(s) clogged
3. Mislocated crossover tube
4. Burner orifice(s) diameter is too small
5. Thermopile leads disconnected or im-
properly connected (Remote-Ready
Models Only)
6. Burners will not come on in remote po-
sition (Remote-Ready Models Only)
1. Manifold pressure is too low
2. Burner orifice(s) clogged
3. Mislocated crossover tube
1. Burner orifice is clogged or damaged
2. Damaged burner
3. Gas regulator defective
1. Not enough air
2. Gas regulator defective
1. Residues from manufacturing processes
and logs curing
1. Turning control knob to HI position
when burners are cold
2. Air in gas line
3. Air passageways on heater blocked
4. Dirty or partially clogged burner
orifice(s)
1. When heated, vapors from furniture pol-
ish, wax, carpet cleaners, etc. turn into
white powder residue
1. Not enough combustion/ventilation air
TROUBLESHOOTING