www.desatech.com
120927-37C
9
CLEANINg AND MAINTENANCE
Continued
REPLACING LOG
1. Remove front trim if applicable.
2. With gloves and safety glasses in place,
remove screws and bracket holding front
glass in place. Remove glass and set
aside carefully (see Figure 8).
3. Remove screws from each side of log that
holds log to log base and remove log (see
Figure 9).
4. Replace new log using screws removed
in step 3.
5. Replace front glass, bracket and
screws.
6. Replace trim.
REPLACING EMBER STRIP
1. Follow steps 1 through 3 under
Replac
-
ing Log
.
2. Locate ember LED strip (see Figure 9).
Disconnect wire (right side)
3. Remove ember LED strip by squeezing
top of standoffs and discard.
4. Connect new ember LED strip using exist-
ing standoffs.
5. Reconnect wire to LED strip.
6. Follow steps 4 and 5 under
Replacing Log
.
REPLACING HEATER/BLOWER
1. Remove screws from around top panel of
firebox (see Figure 10).
2. There are several wires attached to the
top panel. Carefully lift top panel.
3. Disconnect heater/blower wires from main
circuit board.
4. Remove screws holding heater/blower to
top panel (see Figure 10).
5. To remove heater from blower, remove 4
screws (2 per side).
6. Replace blower or heater. Replace screws
removed in step 5 (see Figure 11).
7. Hold heater/blower in place against top
panel, along with spacers if provided, and
replace screws removed in step 4.
8. Reconnect wires to main circuit board (see
Wiring Diagram
, page 12).
9. Replace top panel and screws.
Figure 8 - Removing Bracket and Front
Glass
Bracket
with Screws
Front Glass
Figure 9 - Removing Log and Ember LED
Log
Ember LED
Strip with
Standoffs
Figure 10 - Removing Top Panel and
Heater/Blower
Top
Panel
Screws
Screws Securing
Heater/Blower
Figure 11 - Removing Heater from Blower
Heater
Blower
5. After cleaning compartment, replace front
glass, screw, bracket and trim. Reset
circuit breaker.
