![background image](http://html1.mh-extra.com/html/desa/cdcftn/cdcftn_owners-operation-and-installation-manual_2486272004.webp)
111244-01A
For more information, visit www.desatech.com
For more information, visit www.desatech.com
4
LOCAL CODES
Install and use fireplace with care. Follow all local codes. In the
absence of local codes, use the latest edition of The National Fuel
Gas Code ANSI Z223.1/NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
OPTIONAL REMOTE CONTROL ACCESSORIES
LOCAL CODES
PRODUCT FEATURES
UNPACKING
HOOD ASSEMBLY
OPTIONAL REMOTE
CONTROL ACCESSORIES
(For Remote-Ready Models Only)
There are four optional remote controls that can be purchased
separately for Remote-Ready Models only:
• wall switch
• hand-held ON/OFF remote
• wall thermostat
• hand-held thermostat remote
See Accessories, pages 36 and 37.
PRODUCT FEATURES
SAFETY PILOT
This fireplace has a pilot with an Oxygen Depletion Sensing (ODS)
safety shutoff system. The ODS/pilot is a required feature for vent-free
room fireplaces. The ODS/pilot shuts off the fireplace if there is not
enough fresh air.
PIEZO IGNITION SYSTEM
This fireplace has a piezo ignitor. This system requires no matches,
batteries, or other sources to light fireplace.
THERMOSTATIC HEAT CONTROL FOR
THERMOSTAT-CONTROLLED MODELS
Thermostat-Controlled models have a thermostat sensing bulb and
a control valve. The thermostat will automatically modulate the heat
output to maintain a consistent room temperature. This results in
greater fireplace comfort. This can also result in lower gas bills.
UNPACKING
1.
Remove fireplace and hood from carton. Log is wrapped and
inside fireplace. Do not remove at this time.
2.
Remove all protective packaging applied to fireplace for
shipment.
3.
Make sure your fireplace includes one hardware packet.
4.
Check fireplace for any shipping damage. If fireplace is dam-
aged, promptly inform dealer where you bought fireplace.
HOOD ASSEMBLY
Tools Required:
• Phillips screwdriver
• slotted screwdriver
• 5/16" hex wrench
• scissors
1.
Lift fireplace screen up and pull out to remove (see Figure 2).
Set screen aside until installation has been completed.
2.
Cut two plastic straps to remove the log from the firebox cavity.
Set log aside.
3.
An optional blower is available. See Accessories, pages 36 and
37. Install optional blower now. Follow installation instruc-
tions provided with blower and see page 12 for Remote-Ready
Models or page 13 for Thermostat-Controlled Models.
4.
Locate four black phillips sheet metal screws in hardware packet.
5.
Slide hood between louver and firebox top and align screw holes.
6.
Insert screws as shown in Figure 3. Tighten screws firmly.
Figure 2 - Removing and Installing Screen
WARNING: Always have screen in place before
operating fireplace. This prevents excessive tem-
peratures on fireplace surfaces.
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this fireplace may result in
property damage or personal injury.
Screen
Shoulder Screw
Figure 3 - Assembling Hood
Hood
Sheet Metal
Screws
Firebox Top
Louver