123674-01A
2
www.desatech.com
Header #4
Header
Assembly
Block
Mantel Top #5
Assembly
Blocks
Assembly
Blocks
1
1
/
4
"
Screws
Figure 1 - Installing Base Support
Figure 2 - Installing Header
Base #1
1
1
/
4
" Screws
Base Support #6
1
1
/
4
"
Screws
Left Leg
Assembly #3
Right Leg
Assembly #2
Figure 4 - Installing Mantel Base
1
1
/
4
"
Screws
Mantel Legs
Flush with
Mantel Base
Figure 5 - Installing Mantel Top
IMPORTANT
: Align mantel left to right on base before install-
ing. Corner of mantel legs must be flush with back of mantel
base before installation (see Figure 5). Use a tape measure
to insure accuracy.
Corner of
Mantel Legs
Must be
Flush with
Edge of
Mantel Top
1
1
/
4
" Screw
Heat Reflector
Strip #8
Header #4
Figure 3 - Installing Heat Reflector Strip
IMPORTANT:
Make sure heat reflector strip is flush against
header and spacers are on bottom side. Heat strip should
NOT be flush with leg side but should have 1" clearance on
both ends.
IMPORTANT
: Align mantel top left to right before installing.
Back corner of mantel leg must be flush with edge of mantel
top before installation.
Right Leg
Assembly #2
Left Leg
Assembly #3
Base #1
