MOUNTING AND CONNECTING SWITCh
1. Remove 2 connectors from ON/OFF rocker switch located on wiring
harness. See Figure 5.
2. Insert rocker switch into lower louver panel with switch lever pointing
outward.
3. Reconnect previously removed wire connectors onto switch terminals.
4. Insert supply plug into one of the available power receptacles at the right
side of compartment. See Figure 5.
IMPORTANT: Be sure to inspect components and wiring for damage before
restoring power to appliance. If damaged, contact an authorized dealer for
original replacement part(s) or call DESA Heating, LLC at 1-866-872-6040
for referral.
Power Receptacle
Figure 5 - Connecting Switch and Supply Plug
Blower Supply Plug
Wire Connectors
Blower Rocker Switch
COMPLETING INSTALLATION
1. Reinstall louver panel (if equipped) into framed opening with louvers
pointing upward.
2. Apply wiring diagram label (shown in Figure 6) to control cover and
replace cover back over compartment opening.
3. Reinstall front refractory panel and glass doors in reverse order shown
in Figure 2, page 1.
4. To operate, turn rocker switch to the ON position.
Figure 6 – Wiring Diagram
109690 01
DESA Heating, LLC
2701 Industrial Drive
Bowling Green, KY 42101
1-866-672-6040
www.desatech.com
109690-01
Rev. C
10/07
NOT A UPC
