www.desatech.com
9
113681-01A
18
3
/
4
"
Min.
16
1
/
2
"
Min.
13"
18
3
/
4
"
Min.
13"
Min.
Adjoining W
all
13"
Adjoining W
all
Only Insert Mounting
Screws Through Last
Hole On Each End
Only Insert Mounting
Screws Through Last
Hole On Each End
Floor
Floor
9"
20
1
/
2
"
Min.
9
1
/
2
"
Min.
Adjoining W
all
Only Insert Mounting
Screws Through Last
Hole On Each End
Floor
Removing Front Panel Assembly Of
Heater
1. Remove the two screws, one on each side of
front panel assembly.
2. Pull bottom of front panel up and forward,
then out.
3. Remove any remaining packaging materials.
Figure 7 - Removing Front Panel
AssemblyOf Heater
Screw
Front Panel
Assembly
INSTALLATION
Continued
Methods For Attaching Mounting
Bracket To Wall
Only use last hole on each end of mounting bracket
to attach bracket to wall. On the bracket for the 3
and 5 plaque heaters, these two holes are 13 inches
apart at centers. On the bracket for the 2 plaque
heater, these two holes are 9 inches apart at centers.
Attach mounting bracket to wall in one of two ways:
1. Attaching to wall stud
2. Attaching to wall anchor
Attaching to Wall Stud:
This method provides the
strongest hold. Insert mounting screws through
mounting bracket and into wall studs.
Attaching to Wall Anchor:
This method allows you
to attach mounting bracket to hollow walls (wall
areas between studs) or to solid walls (concrete or
masonry).
Decide which method better suits your needs. Ei-
ther method will provide a secure hold for the
mounting bracket.
Marking Screw Locations
1. Tape mounting bracket to wall where heater
will be located. Make sure mounting bracket
is level.
5 Plaque Heaters
2 Plaque Heaters
Figure 8 - Mounting Bracket Clearances
WARNING: Maintain mini-
mum clearances shown in Fig-
ure 8. If you can, provide greater
clearances from floor and join-
ing wall.
2. Mark screw locations on wall (see Figure 8).
Note:
Only mark last hole on each end of
mounting bracket. Insert mounting screws
through these holes only.
3. Remove tape and mounting bracket from wall.
3 Plaque Heaters
