- 8 -
Mounting the transformer on the ceiling
1. Unroll the suspending cables and put them on the ground flat and parallel.
2. Remove the cover plate from the transformer housing by lifting it with little force (please see Fig.
4
). The lid is held in place by four barbed hooks. Slide the lid over the suspending ropes until it
rests on the projection lamp.
3. Lay down the projection lamp on a table or ladder underneath the mounting position, so that you
can reach the ceiling without having to lift the projection lamp. You may need a second person to
support you if the ceiling is very high.
4. Hold the transformer housing to the ceiling and mark the positions for the two screws. Make sure
that the connecting wire enters the housing through the intended opening (see Fig. 5).
5. Put the transformer housing to the side and install the drill holes and rawlplugs at the ceiling.
6. Screw the transformer housing to the ceiling. Check that it is mounted safely and tightly.
7. Connect the wires free of stress to the double luster terminal at the transformer housing.
8. Attach the luster terminal to the provided retaining clip (see Fig. 5, magnification underneath).
Fig. 4: Opening the transformer housing
Fig. 5: Interior view on the transformer housing
Summary of Contents for bil
Page 1: ...Reference Manual 115V ...
Page 2: ... 2 Illustration 1 ...
