Derbi boulevard 125 4t, Workshop Manual

Page: 102 / 182

Refitting the ub cover
- Fit a new gasket together with the centring dow-
els.
- Fit the gearbox cover, making sure the breather
pipe is in the correct position.
- Screw the 7 screws to the specified torque, po-
sitioning the support plate of the pipe in the posi-
tion shown in the figure.
- Remove the control pin of the shoe taking care
so as the long tooth coincides with the groove on
the control lever.
Locking torques (N*m)
Locking torque 24 ÷ 27
Flywheel cover
Cooling hood
-Remove the housing acting on the 4 retaining
screws.
CAUTION
DURING REMOVAL SLIDE THE HOUSING
CONNECTOR ON THE HOUSING.
- Loosen the clamp and remove the carburettor
from the manifold.
-Remove the complete manifold acting on the 2
retainers as shown in the figure.
- Remove the 2 self threading screws, left and right
and the lateral base retaining screw on the crank-
case base.
- Take off the housings.
- Remove the gasket seal of the housing on the
head.
N.B.
Engine
ENG - 102