12
EN
EN
ELECTRIC CHAINSAW
2
1
2
1
3
Fig. 16
Fig. 17
MAINTENANCE
ATTENTION!
All maintenance work may only be carried out with the power off.
Conducting timely maintenance will extend the life of the device and increase work efficiency. The device
must be serviced, except for the operations mentioned here, by qualified personnel at our authorized service
centres.
Each time after completing work, check the device for component integrity and connection reliability. Contact
an authorized service centre, if necessary.
Cleaning the device
ATTENTION!
Do not use water or other liquids for cleaning
Be cautious when cleaning the device. Always wear protective gloves. Turn off the device. Unplug the power
cable from the wall socket. Wait approximately 10-15 minutes for the motor to cool completely. Wipe all sur-
faces and ventilation openings with a dry cloth or rag; if necessary, use a special brush.
To ensure the perfect operation of the oil pump, it is necessary to periodically clean the oil-conducting groove
1 (Fig. 18) and the oil-conducting hole in the saw bar 2 (Fig. 18).
The bar service
Regularly lubricate the gear at the top of the bar. Proper bar care, described in this section, is essential to the quality
of the chainsaw.
To lubricate the sprocket, the use of a grease gun is recommended (not included).
To service the bar sprocket:
1. Disconnect the device from the mains.
2. Clean the sprocket of the bar.
3. Place the needle-shaped nozzle of the syringe into the grease hole and inject grease until it appears on the outer
edge of the bar sprocket (Fig. 19).
4. Move the chain manually. Repeat the above lubrication procedure until the entire bar sprocket is lubricated.
For uniform wear, the bar should be rotated every 8 hours of operation. Keep the bar groove and lubrication
hole clean with a cleaning tool (not supplied) (Fig. 20).
Summary of Contents for 956127
Page 135: ...135 ...
Page 136: ......