AC OPERATION
Before operation please ensure that the voltage on the set corresponds to the
voltage of your local area. Unravel the AC Line Cord; insert one end into AC
socket on the unit and the other end into a standard AC outlet.
Remarks:
1) In case of malfunction due to electrostatic discharge (ESD), reset the unit by
re-connecting the AC cord again to resume to normal operation.
2) When not in use – Unplug the AC power cord completely from the AC power socket.
Warning:
The power cable/disconnect device shall remain easy to operate/disconnect.
BATTERY OPERATION
Disconnect the AC Cord Set completely. Open the BATTERY DOOR and insert
UM-2/ “C” size x 8 batteries (not supplied) making sure that the indicated
battery polarity is observed.
When not in use – remove all the batteries if the unit will not be used for
several months or more.
RADIO OPERATION
1.
Slide the FUNCTION SWITCH to the “RADIO” position.
2. Slide the BAND SWITCH to the desired waveband (FM or FM ST.).
3.
Turn the TUNING KNOB to your desired radio station.
Note: Radio frequency is shown on the LCD DISPLAY.
4.
Adjust the sound level by rotating the VOLUME CONTROL KNOB.
5.
To turn off the radio simply slide the FUNCTION SWITCH to “TAPE/OFF”
position.
FM STEREO INDICATOR
Tuning to a FM stereo broadcast station the “FM ST.” LED indicator will light
up. In weak signal areas the FM Stereo signal may not be strong enough and
can cause excessive background noise. In this case, slide the BAND SWITCH
to “FM” position.
ANTENNAS
For best reception, fully extend the FM ANTENNA to receive FM stations.
BASS BOOST
To increase bass at all volume levels, push the BASS BOOST BUTTON to “ON”
position to boost the low frequency tone for an emphasized bass sound.
To release the super bass simply push the button again.
English - 2
