Denver DTX-2128, User Manual

Page: 4 / 20

4. Switch on your TV with the power switch on the front panel.
If the screen does not light up, press a button P+ or P- on the front of the television set
or any key such as POWER,
or , 0, 1, …9 on remote control.
Notes:
1. After switching the television set on by using power button on front panel, the set
switchs to the same mode as it was before switching off by this button. If TV set
was switched off by using the POWER key on remote control, it switches to standby
and the indicator LED on the front panel turns red.
2. After switching television set from standby to operating status, the indicator LED
turns to green from red.
Quick Start Guide
1. Fit the Batteries into the Remote Control according to the diagram in the battery compartment.
2. Plug your main home aerial into the TV set.
3. Plug your TV into the mains and switch ON by pressing the power button on the front panel. If
your TV screen does not light up, press the
POWER, , key or any digital key on the hand unit
to cancel standby mode.
4. On your remote control press the
"OK" key once. The main menu will appear on the screen.
5. On your remote control use the key 18 (P+, P-) to select Installation icon.
6. On your remote control press the key once to select Installation menu.
7. On your remote control press the key four times to select Auto store item.
On your remote control press the key P- twice to run Auto store . Your TV will now automatically
tune and store your local available TV stations. This may take a few minutes.
8 . Select your favorite program by using the , keys or the digital keys.
9 . Set your favorite volume level by using , keys.
Remark: If You forget the child lock code or dial it wrongly, press code 4711 on remote
10. You may change code the lock after TV will switch on. Refer to the instruction booklet for further
information about the many other facilities.
Remark: When there is no signal in the aerial socket, the TV screen will appear in blue colour
if the Blue back item is set to On in Features menu.
2
Position
For best results, choose a position where light does not fall directly on the screen and
away from sources of heat. Do not put objects with magnetic field nearby the television or it
could affect the quality of the colours.
Cleaning
Switch off and unplug the television and use only a lightly dampened soft cloth to clean it.
Do not use chemically active substances as these may damage the cabinet finish.
Standby
For convenience your television can be switched to standby with the remote control. To
preserve optimum picture quality (by de-magnetising the picture tube), we advise you to
switch off your television at the on/off switch regularly.
Switching on
1. Remove the battery cover from the remote control unit and install two AA type batteries
according to the diagram inside the battery compartment. Replace the battery cover.
2. Connect your aerial to the TV set.
3. Connect your TV to a 230 VAC power socket.
ٛ
Notice: Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type.
control by pressing digital key to unlock the locked program.