TROUBLESHOOTING
Problem
Reason(s)
Solution(s)
No Power
The Power switch is set to OFF
Batteries are flat
Set the Power switch to the ON position
Replace the batteries or use mains power
Desired station not
found
Weak signal Station not available in
your area
Use the manual tune function
The display is blank
This may occur if the broadcaster
changes the label of a service or
removes a label while tuned.
The unit will try re-tune. If not perform a new
scan
I can hear a burbling
noise on some
stations
Battery power is low weak signal
Replace the batteries or use mains power Try
re-positioning the antenna
No sound
Volume set to minimum
Increase the volume level