DENTSPLY X-SMART Endo Motor, Operation Manual

Page: 26 / 32

26
J> Error Code
If the motor handpiece stops due to an abnormality such as a malfunction,
overload, breakage or misuse, it automatically checks the state of the control unit
>˜`Ê `iÌiVÌÃÊ Ì iÊ V>ÕÃiÊ œvÊ Ì iÊ >L˜œÀ“>ˆÌÞ]Ê `ˆÃ«>ވ˜}Ê >˜Ê iÀÀœÀÊ Vœ`iÊ œ˜Ê Ì iÊ Ê
panel. If an error code is displayed, turn on the power again and check whether
the same error code is displayed. If the same error code is displayed, take action
LÞÊÀiviÀÀˆ˜}Ê̜ÊÌ iʈ˜ÃÌÀÕV̈œ˜ÃÊ«ÀœÛˆ`i`ʈ˜ÊÌ iʺ iVŽÉ,i“i`Þ»ÊVœÕ“˜Êˆ˜ÊÌ iÊ
following table.
NOTICE
If batteries are replaced while the AC adapter is connected, an incorrect error
code may be displayed.
Error code Error Cause iVŽÉ,i“i`Þ
During
rotation
of the
motor
handpiece
E-O
Self-Check error Malfunction of
circuit. Contact your Technical
Service Department.
E-1
Overcurrent The motor
handpiece is
locked (at the
time of the auto
reverse mode). ,i“œÛiʏœ>`°
E-2
Overvoltage Malfunction of
circuit. Contact your Technical
Service Department.
E-4
Overheating of motor High load was
continuously
applied to the
motor handpiece
for a relatively
long time.
Leave it as it is until it cools
down.
E-5
Error of the brake circuit Malfunction of
circuit. Contact your Technical
Service Department.
E-6
The axle locks up The motor
handpiece is
locked (at the
time of startup). ,i“œÛiʏœ>`°