Dentsply Sirona Propex Pixi, User Manual

Page: 22 / 645

Step-by-Step Instructions
22/645 END-IFU-PROPEX-PIXI-V15-WEB-EUR-Multilingual-2021-10
6.8 Demo Mode
The built-in demo mode is available to become acquainted with the
device and to demonstrate its operation.
1. Disconnect the measuring cable or the charger from the device, if
connected, and turn the device off.
2. To start the demo mode, press and hold the “ON / OFF” button
for about 2 seconds. until the whole display turns on ( Fig. 13 ) and
immediately turns off again accompanied by two beeps.
Fig. 13
3. During the demo cycle the device operating sequence is shown on
the screen.
4. Demo cycles are repeated automatically until interrupted by the
operator.
5. To exit the demo mode press the ”ON / OFF” button and hold for
about 1 second until a beep sounds. The device shuts down.
Note
If the measurement cable is connected to Propex Pixi
®
during the
demo cycle, the device switches automatically to normal operation
mode.