Dentsply Sirona
Operating Instructions CEREC AC Connect
6 Installation and startup
6.4 Initial startup
64 32 087 D3492
D3492.201.07.24.02 07.2018
33
6.4.3
Plug connections
NOTE
The CEREC Omnicam is a high-precision optoelectronic scanning
instrument for non-contact impression taking which requires careful
handling. Incorrect handling (impacts, dropping) leads to failure of the
CEREC Omnicam.
➢ Always deposit the sensitive CEREC Omnicam in its holder!
NOTE
Do not damage cable
If you pull on the cable itself in order to unplug it or to check the plug
connection, you will damage the cable.
➢ Never pull on the cable.
➢ Slide the moving part of the plug-in coupling upward on the
CEREC AC Connect. At the same time, hold the camera
connector in place.
1.
Connect the unit to the line voltage with the power cord.
2.
Carefully insert the connector of the CEREC Omnicam cable into
the coupling on the CEREC AC Connect, watching out for the guide
nose.
3.
Check the plug connections of the power supply and the camera.
The CEREC Omnicam always remains connected.
Notes on network installation
The network card is installed.
The cable with the RJ-45 connectors establishes the network
connection. The network software and the driver for the network card
must be installed by your network administrator.
Summary of Contents for CEREC AC
Page 91: ......
