15. Warnings
Please observe the following instructions for installing your Density fog unit:
1.
This appliance is not intended for use by person (including children) with lack of experience and
knowledge, unless they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
2.
Children should be supervised to ensure that they do not play with this appliance.
3.
The machine must be installed avoiding to obstruct escape routes. (according to EN50131-8:2019)
4.
Verify the fog does not limit the visibility near: stairs, landings, moving objects that may cause falls,
injuries or any damage to persons.
5.
When using the product in multi-storey buildings, if the escape route runs through an area which is
protected by a fogging system, it is recommended to install a vocal warning that provides instructions on
the behavior to observe.
6.
Do not look directly into the nozzle. Do not add any other substance into the refill.
7.
The nozzle may reach high temperatures, touch it may cause burns.
8.
When Density unit produces fog avoid staying closer than 1 meter from the machine.
9.
Before testing the unit, remember to report it in advance to the firefighters in your area to avoid false
alarms.
10.
Remember to put provided warning and deterrent labels about the presence of Density on the front
and back door windows.
11.
Report its installation to the firefighters in your area and to other institutions if needed.
12.
It is necessary to add an external switch to separate the fog generator from the alarm system and it
should be activated before the maintenance to avoid that input tests, for example, can activate the fog
generator.Before maintenance it is suggested to put the unit in service mode. (See section 8: Dipswitch)
13.
Never direct the fog jet towards an object or a wall less than 2 meters away and, if possible, increase
the suggested minimum distance. Thanks to the power of the jet, the unit reaches and exceeds more than
10 meters away in the first 3 seconds from the point where the machine is installed.
14.
Setting the shooting time interval between the minimum and maximum shown in the shooting table
(Section: 9), avoid “overshooting” even if the produced fog is dry and generally doesn’t leave residue. A
shot that goes far beyond the recommended seconds can create a residue in the room.
15.
Install -if possible- at the height of about 2,5 meters not to let it be reached, avoiding possible
tampering.
16.
Do not move the machine when it is still hot.
17.
The main body of the unit, which has the heating system enclosed inside a metal frame, should not be
opened unless you are an authorized service center. Do not open and touch for any reason the insulation
before 24 hours unit has been shut off. The internal part may reach high temperature.
page 19/20
www.densityglobal.com | [email protected]
Version 1.1.4
