4
www.dension.com
*DWHZD\
*DWHZD\
*DWHZD\
*DWHZD\
5DGLR
5DGLR
5DGLR
5DGLR
iPod
iPod
%7$
%7$
%7$
%7$
Microphone
Miic
BTA
1.
Make sure the phone module functionality is enabled on the car and remove any pre-
installed phone module
2.
Connect the iPod dock cable to device port 1 (DP1) on the Gateway 500 (if you are
using the BTA1000, you’ll need to disconnect it from device port 1 first)
3.
Download the latest Gateway 500 firmware (FW) from
www.dension.com
4.
Connect the BTA1500 to the device port 2 (DP2)
5.
If you want to use the BTA1500 for handsfree telephony, connect the microphone to
the BTA1500 mic port (3.5mm connection). Refer to 3.2 for positioning the
microphone
6.
Do
not
connect any mute cables between BTA1500 and the audio system of the car
7.
When you switch on the BTA1500 for the first time, turn ignition/car off until the
5.2 Positioning the microphone
•
For optimum handsfree performance, position the microphone as close to the driver’s
mouth as possible, but at the same time in a central location, i.e. an equal distance
from the left and right speakers. Ideally, clip the microphone to an overhead panel at
the top of the windscreen, for example, near the interior light.
•
When using BTA1500 for hands-free operation, ideally set the volume to a moderate
level to avoid feedback.
•
We recommend setting your phone volume to a similar volume as the other audio
sources connected to the Gateway. Do this on your phone.
blue LED on the AUX box stops lighting so the MOST ring shuts down.
Then turn the system on again.
Gateway 500
Radio
DP1
BTA 1500
Microphone
Mic
DP2
iPod
