17
The Controls on Top of DHT-T100
1) Power on/standby
2) Television Input
Listen to sound from the television; auto-selects the active signal.
Should multiple inputs have signal present, priority is given to optical-digital, coaxial-digital,
and 3.5mm analog stereo mini plug, in that order.
3)
Bluetooth
® Input
Listen to wireless audio streamed from your
Bluetooth
enabled mobile device.
(see "Using Bluetooth®" on page 19).
4) Remote Learning
Press to engage Learning Mode. (see "Use Any Remote to Control your DHT-T100" on page 20).
5) Listening Mode
Toggles through the five Listening modes (see "Listening Modes" on page 18).
6) Mute sound
Mutes the audio; press again to unmute. (Pressing either Volume key also unmutes).
7) Volume down
Press-and-hold to continuously decrease the volume.
8) Volume up
Press-and-hold to continuously increase the volume.
About DHT-T100's Automatic Power Modes
DHT-T100 will automatically “wake-up” whenever any of its wired inputs receives an audio signal. Simply turning on your
television will also turn on DHT-T100. (For
Bluetooth
playback you will need to turn on DHT-T100 manually using the remote
control or top panel. controls). Because of DHT-T100’s power saving design, the system takes five to seven seconds to turn
on from standby. Pressing either the front-panel Television Input or
Bluetooth
keys will also power up the DHT-T100. Press the
Power key again to return DHT-T100 to its low-power “standby” mode. DHT-T100 will automatically return to standby after five
minutes of not receiving any audio, for example, after you turn off your television set.
If you wish to change this auto-on behavior
you may switch between the standard automatic wake-up/standby mode,
and a manual power on/standby mode. To change from one to the other, press-and-hold the front panel Power key for
three seconds. The power key LED will flash bright for three seconds, then illuminate steadily for three seconds, and then go
completely dark, indicating you have changed to manual power mode. Each time you repeat the Power-key press-and-hold it
will change to the other mode. In manual power mode DHT-T100 is switched to on or standby with a momentary press of the
Power key.
1
2
3
4
5
6
7
8
DHT-T100E2_10A_131201.indd 17
2013/12/02 13:28:07