ENGLISH
ENGLISH
11
Page
Measures
Cause
Symptom
Troubleshooting
If a problem should arise, first check the following.
1. Are the connections correct?
2. Have you operated the player according to the Operating Instructions?
If this unit is not operating properly, check the items listed in the table below. Should the problem persist, there may be a malfunction.
Disconnect the power immediately and contact your store of purchase.
Disc tray does not open.
• The power is not on.
• Turn on the power.
7
“0 000 00:00” is displayed even
though a disc is loaded.
• The disc is not properly loaded.
• The loaded disc is not a CD.
• Reload the disc.
• Load a CD.
2, 3
2
Disc is not played when
1
button is
pressed.
• The disc is dirty or scratched.
• Wipe the dirt off the disc or replace the disc.
3
No sound is produced or sound is
distorted.
• The output cables are not properly connected to the
amplifier.
• The amplifier’s function setting or adjustments are
not right.
• Check the connections.
• Check the amplifier’s function and controls and
adjust as necessary.
6
–
No digital signals are output.
• The connection cables are not properly connected.
• Check the connections.
6
Specific section of the disc cannot be
played properly.
• The disc is dirty or scratched.
• Wipe the dirt off the disc or replace the disc.
3
Programmed playback is not possible. • The tracks have not been programmed properly.
• Program properly.
9
A CD-R or CD-RW disc cannot be
played.
• The disc has not been finalized.
• The recording conditions are bad or the quality of the
disc itself it poor.
• Finalize the disc then play it.
• Use a properly recorded disc.
2
2
Set does not operate properly when
remote control unit is operated.
• The batteries are spent.
• The remote control unit is too far from the set.
• Replace the batteries with new ones.
• Move the remote control unit closer to the set.
3
3
“– – : – –” is displayed when playing
files recorded in MP3 or WMA format.
• You have selected a copyright-protected WMA file
or a file that cannot be played normally.
• Use the
8
/
6
or
7
/
9
button on the main
unit (the
8
or
9
button on the remote control
unit) to select a different file.
2
