Make sure to initialize this unit after replacing the microcomputer or any peripheral equipment, or the
PCB.
1. While the power is On, hold down buttons "
SOURCE
" and "
EJECT
" for at least 5 seconds.
2. "
RESET
" is displayed for 3 seconds.
3. After initialization, the Unit returns to normal mode.
NOTE
: • If the unit fails to enter the service mode in step 2, repeat the procedure from step 1.
• Initializing the device restores the customized settings to the factory settings. Write down
your settings in advance and reconfigure the settings after initialization.
X
5
SOURCE
Initializing this Unit
POST-SERVICE PRECAUTIONS
Before Servicing
This Unit
Electrical
Mechanical
Repair Information
Updating
7
