Denon AVR-2309CI, Service Manual

Page: 19 / 160

19
AVR-2309CI/AVR-889
CHECK WITH TEST MODE
µcom/DSP Error Display Mode
Operation Spec
µcom version display mode:
When the following conditions are satisfied at its starting state, error information is displayed before version information.
Starting method (same as µcom version display):
E3 model
While pressing 2 buttons, "DYN VOL" and "VIDEO SELECT", turn on ON/OFF button.
Then, press "STATUS" button to display the following information on the FL Display.
Display Order
Error information → Destination information → Main-µcom version information → Sub-µcom version information
→ DSP version information
Display
Any one of the following list is displayed, in the priority of ①②③④ .
Condition State Display
①
Sub-µcom NG
No response from Sub-µcom
" □ ＳＵＢ □□ ＥＲＲＯＲ □０１□ "
②
DIR NG
No response from DIR
" □ ＤＩＲ □□ ＥＲＲＯＲ □０１□ "
③
DSP NG
When DSP boot, executing DSP reset makes no change to DSP FLAG 0
port "H".
" □ ＤＳＰ □□ ＥＲＲＯＲ □０１□ "
No change to DSP FLAG 0 port "H" before issuing DSP command.
" □ ＤＳＰ □□ ＥＲＲＯＲ □０２□ "
When DSP data read, executing WRITE="L" makes no change to
ACK="H".
" □ ＤＳＰ □□ ＥＲＲＯＲ □０３□ "
When DSP data read, executing REQ="L" makes no change to
ACK="L".
" □ ＤＳＰ □□ ＥＲＲＯＲ □０４□ "
When DSP data write, executing WRITE="H" makes no change to ACK="H".
" □ ＤＳＰ □□ ＥＲＲＯＲ □０５□ "
When DSP data write, executing REQ="L" makes no change to
ACK="L".
" □ ＤＳＰ □□ ＥＲＲＯＲ □０６□ "
When DSP special code boot, executing DSP reset makes no change to
DSP FLAG 0 port "H".
" □ ＤＳＰ □□ ＥＲＲＯＲ □１１□ "
No change to DSP FLAG 0 port "H" before issuing DSP special read
command.
" □ ＤＳＰ □□ ＥＲＲＯＲ □１２□ "
No change to DSP FLAG 0 port "H" before DSP version read.
" □ ＤＳＰ □□ ＥＲＲＯＲ □１３□ "
④
Both SUB/DSP OK
(No error display, version display only)
ON/OFF button VIDEO SELECT
DYN VOL STATUS
E3 model
s