Operating Instructions
1. Charging batteries.
a. Plug the power adapter (1) into a power outlet and connect to battery charger unit (2). A single green light will indicate
power to the charger.
b. Slide the battery from the power pack (3) into the charger unit (2) with connectors facing the pins. Make sure the
battery is lying flat on the charger base prior to
sliding it forward to engage charger terminals.
Note: Pushing the battery forward without keeping it flat may damage charger pins.
c. When the battery is inserted into the charger, the charger status light turns from green to red to indicate that charging
has begun.
d. Once the battery is fully charged, the light will return to green.
2. Mounting the Light on to Loupes.
Attach the lamphead to loupes using the supplied mount and hardware.
Flip style loupes (PeriOptix,
®
Surgitel,
®
Orascoptic,
®
etc.)
Slide clip onto front of interpupillary cross bar of loupes, with one circular cut-out on top and one cut-out on the bottom
of the cross bar. The clip should securely snap into place.
Through-The-Lens (TTL) solid bridge mount
Loosen the thumb nut on bridge clamp, opening the two halves wide enough to engage the top and bottom of frame
nose bridge. Attach the clamp to the bridge so that the grooves in the jaws grab the top and bottom edges of the
bridge and then tighten nut.
Universal Mount attachment to eyeglass frames
Open the clip and slide down over the top of the nose bridge. The padded arms of the
clip should grasp each side of the eyeglass lenses. Tighten thumb screw to secure clip to frame.
3. Clip the power pack to your waist band or pocket.
a. Attach the lamp cord to the loupe frames with the small elastic strap.
b. Use the shirt clip on the lamp cord to position the cord on your shirt or lab coat as desired.
c. Remove battery from charger unit and slide into the power pack. The battery should snap into place.
4. Turn on lamp using on/off button.
a. The intensity control knob will adjust lamp intensity.
5. Adjust the direction of the LED beam.
a. To adjust the tension of the lamp head position, use the supplied phillips screwdriver to tighten or loosen the two
small link screws as needed.
6. Precautions.
a. Equipment in medical environments , including this product, can produce electromagnetic interference (EMI).
These effects are prevented by the use of equipment with EMI characteristics below proven recognized limits for the
specified operating environment. In the event of suspected electrical interference with other equipment, cycle the power
on the Solaris to remedy the EMI effect.
denmat.com
Operating Environment:
• 10° - 30°C (50° - 86°F)
• 95% or less relative humidity
• 70kPa – 106kPa
Transport/Storage:
• 0° - 40°C (32° - 104°F)
• 95% or less relative humidity
• 70kPa – 106kPa
Technical Data:
Headlight System:
Internally powered by 7.2Vdc, 2500 mAH
rechargeable Lithium-ion battery pack
Solaris (LED2-BP):
730mA
Mini (LED4-BP):
540mA
Power Supply:
100 – 240V~, 50 – 60 Hz, 0.5A
Definition of Symbols
User Must Read Instruction Manual
Class II Equipment
Alternating Current
Direct Current
European Conformity
For Indoor Use Only
Recycle for Lithium-ion
Recycle or Dispose of
Properly
Caution, Consult Documents
