bio.x C500 135147
Page 7 of 12
07/2008
8. Maintenance
Warning!
Before starting work on the cleaning table fixtures, switch off the electrics and unplug
from the mains! Test the equipment to ensure the power is off!
The unit can be opened at the side for servicing or to fill the tank with fresh detergent. To do so, lift up the
right-hand side of the unit top and prop it up using the bar you can find inside.
Servicing position for unit top
8.1 Fill level
Check the fill level against the markings on the tank wall regularly so you can refill to make up for any losses
through evaporation and removal. If the fill level falls under a minimum of 60 litres (lowest marker line), the
pump and the heating system switch off automatically for safety reasons. In such a case, "LO" is shown on the
display. Re-fill the detergent until the top marker line is reached. The message will disappear once there is
enough detergent in the tank.
8.2 Additive
More additive should be put in every 6 months to replenish the micro-organisms.
After refilling, the detergent must be left to stand for 24 hours so that the micro-organisms can become active.
It is therefore recommended to refill with the additive before a weekend.
8.3 Filter
The washstand is equipped with two filters as standard. A stainless steel perforated filter on the washstand
surface and a synthetic filter for impurities underneath. It is recommended to clean these filters on a daily
basis. To do so, remove the filters from the unit and rinse with water.
8.4 Cleaning fluid
The cleaning fluid has to be replaced if
-
there is a significant fall in the cleaning performance
-
when checking the fill level there are notable sediment deposits on the floor of the tank
After you have taken out the used cleaning fluid, the tank has to be freed of any sediment residue.
Please follow the same process when inserting the new fluid as for the initial operation.
