DENAVO DHS-700RX, User Manual

Page: 17 / 29

- 17 -
1. Install and fix stator onto the SX Pan/Tilt module
2. Push the XS bracket into ceiling and let the clips stretch out, screw the clips to tighten the bracket.
3. Set dome ID and protocol via DIP switches.
4. Connect cables as per cable connection diagram. Match the tabs, push and the Pan/Tilt Module into
XS bracket and tighten the screws on the stator.
IV. T8 type In-ceiling mount for SX series module Installation
(T7 for SX)
1. Cut off the circle from the ceiling.
2. Prepare the cables and put them into the housing.
3. Push housing into ceiling and let the clips stretch out. Finally, screw the three clips to tighten the
housing.
4. Set dome ID and protocol via DIP switches.
5. Insert cables into corresponding sockets on circuit board on Pan/Tilt Module.
6. Turn Pan/Tilt Module clockwise to match tabs into round stator's screw eye and tighten the settled
screw.
7. Match the clasps and mounting holes then turn clockwise.
Back Cover and Bracket Installation (IP66 Protection)