4. Mounting The Switch
4.1 - Handlebar Mounting
All DENALI Light Kits include both 7/8” and 1” handlebar mounting
bands, as well as an adhesive mounting pad.
Step One:
Determine the bar diameter and select the correct size
mounting band, then place the band around the handlebar.
Step Two:
Use the two self tapping screws and a #1 Phillips head screw
driver to attach the switch to the mounting band. Continue tightening
the screws until the switch no longer rotates on the handlebar.
DENALIELECTRONICS.COM
4.2 - Surface Mounting
Step One:
Clean and prep the mounting surface and the bottom of the
switch using an alcohol swab. Allow surfaces to fully dry.
Step Two:
Peel away one side of the backing from the adhesive pad
and adhere the pad to the bottom side of the switch.
Note:
To ensure a stronger bond use a heat gun to warm the tape
before applying to the surface.
Step Three:
Peel away the remaining backing from the adhesive pad
and adhere the switch to the mounting surface using moderate
pressure.
5. Aiming The Lights
5.1 - Suggested Aiming Method
Step One:
With someone sitting on the bike and holding it upright on
level ground, position the vehicle 25 feet from a flat and vertical wall.
Be sure the wall is large enough that both beams can be projected onto
the wall. A garage door is a great place to perform this procedure.
Step Two:
Measure the distance from the ground to the center of the
light pods (H)
Step Three:
Using tape, make a horizontal line that is 2 inches lower
than the previous measurement from the ground to the center of the
lights (H-2”).
Step Four:
Loosen the mounting and hinge bolts then aim each light so
that the center of the hot spot aligns with the tape line on the wall. The
lights should be aimed equidistant left and right from center line of the
vehicle.
Step Five:
Once final adjustments are made to the lights, tighten the
mounting and hinge bolts.
Congratulations! The DENALI LED Light Kit has been successfully
installed! Enjoy! Refer to
Figures 6 & 7
for detailed instructions for
installing optional DENALI Light Kit accessories. To view a full list of
accessories please visit WWW.DENALIELECTRONICS.COM
(25 FEET FROM WALL)
(H-2”)
(H)
(H)
Switch
Mounting Band
Switch
Adhesive Pad
Self Tapping Screws
If you have limited space or are having trouble identifying the hot spot on the wall, you can shorten the distance to 6 feet and mark the tape line at H-1/2".
