3. Configure The CANsmart Controller
DENALIELECTRONICS.COM
4. Wiring For Non-CANbus Vehicles
3.1 - Selecting The Circuit Function
3.2 - Setting The Fuse Value
The CANsmart Accessory Manager will be used to configure your controller
for operation of the USB harness, for further details of how to use the
software refer to the manual that was provided with your CANsmart
Controller.
Step One:
Use the Circuit Function Selector to configure the circuit the
USB Quick Charge 3.0 Harness is connected to to be “Accessory”, then click
apply.
Step One:
Click the fuse value underneath the “Accessory” circuit and set
the fuse value to 2 Amps.
4.1 - Battery Connections
Step One:
Connect the Battery Wiring adapter to the USB Quick Charge
3.0 Harness.
Step Two:
Remove the fuse from the fuse holder.
Step Three:
Access the vehicle’s battery and disconnect the negative
(-) and positive (+) terminals.
Step Four:
Connect the Battery Wiring Adapter to the battery via the
ring terminals, be sure the red wire lead with the fuse holder in-line
goes to the positive (+) terminal of the battery.
Step Five:
Re-install the fuse into the fuse holder.
Note:
When possible, place the fuse holder in an easily accessible
location for convenient service in the event of a blown fuse.
Battery
Negative
Positive
Fuse Holder
USB Quick Charge 3.0 Harness
Battery Wiring Adapter
