© DENAFRIPS CO. LTD. & VINSHINE AUDIO PTE. LTD. (SINGAPORE)
ALL RIGHTS RESERVED
3.
OPERATING INSTRUCTION
3.1
Quick Start Guide
Package Contents
AVATAR CDT
Disc Clamp
Remote Control
–
CR2032 battery is required
Disc Loading
To open the AVATAR top loading door, slide the lid towards the rear of the unit fully. The
CDM4 assembly shall be visible, and the Disc Clamp shall be accessible.
Lift the Disc Clamp gently by holding the centre part of the Disc Clamp. Place a disc to the
centre of the disc holder. Place the Disc Clamp in the centre of the disc and disc holder.
The Disc Clamp is magnetic, once it is in position with the centre of the CDM4 spinner, you
should feel the grip. Please note that the Disc Clamp must be in the correct position for the
CDT to be operational.
Slide the top loading lid towards the front of the unit fully. The micro limit switch must be
triggered for the CDT to be operational.
Change Disc
It is recommended to stop playing the current disc before changing the disc. This allow the
CDM4 mechanism motor to stop spinning gradually. Press Stop button on the front panel to
stop playing the current disc.
Slide the top loading lid towards the rear of the unit fully. Retrieve the Disc Clamp and Disc
gently. Follow the same steps stated in Disc Loading above.
