Page 17
15448-35 - Hub & SPINDLE bREAKDOWN
1. Tighten castle or slotted hex nut to initial torque indicated on chart while turning hub in both
directions to insure all bearing surfaces are in contact.
2. Back nut off and repeat step #1.
3. Back nut off, do not allow hub to turn.
4. Tighten nut to final torque indicated on chart.
5. Install cotter pin, if needed loosen or tighten nut to the next closest locking slot.
6. Chuck hub for end play.
7. If end play can be felt, start over and readjust bearings. If end play is felt again, try readjusting
with a different castle or slotted hex nut.
8. The bearing are set correctly when no end play can be felt after adjustment.
Wheel bearing Adjustment
ITEM PART # DESCRIPTION
qTy.
1
02990
BOLT, .313 NC X 1.00 HEX HEAD GR.5
4
2
05088
COTTER PIN, .25 X 2.00
1
3
07362
HUB CAP F/ #871 & #873
1
4
09055
OIL SEAL F/ 873 HUB
1
5
09532
HUB CAP GASKET
2
6
15431
SPINDLE, SIDEQUEST GEN3
1
7
15432
10-HOLE NON-BRAKING HUB #873
1
8
13627
OUTER RACE 453A TIMKEN
1
9
15468
INNER RACE 33462 TIMKEN
1
10
15433
BEARING #469 TIMKEN 2.25 ID
1
11
15434
BEARING #33287 TIMKEN 2.875 ID
1
12
15435
WASHER 3.00” OD X .25” THICK
1
ITEM PART # DESCRIPTION
qTy.
13
15436
CASTLE NUT 1-1/2”-12 UNF-2B
1
14
15476
HUB CAP SPACER
1
Please order replacement parts by PART #. and DESCRIPTION.
Hub
Initial Toque
Final Torque
Sq1200
90 ft/ lbs
60 ft/lbs
