I-984
Page 3 of 5
Rev. M-43434 11/10/17
Installation
Mount the unit no higher than 6 feet from the chemical container. Take into account the proximity to the chemical,
drain, and power for the unit. Use the included screw and anchor kit to secure the mounting bracket to the wall and
then mount the unit on the wall. Then cut the tubing to the proper length to reach from the chemical container to the
unit and the unit to the drain where the chemical is being dispensed.
Squeeze Tube Installation
Install the squeeze tube by
removing the pump cover by
depressing the tab on the
front of the unit. (1) Place
one end of the squeeze tube
on the left side of the pump
in the slot provided. (2)
Wrap the squeeze tube
around the rollers of the
pump. (3) Then stretch the
squeeze tube so that the end
of the tube goes into the slot
provided. (4) Replace the
cover on the pump.
(1) (2)
(3)
(4)
Retaining Clip
There is a clip on the bottom of the unit. This is to help relieve strain on
the power cord. Place the power cord through this strain relief to help the
power cord from coming unplugged from the unit.
Clasp Close Pump Heads
The pump heads have an added feature which will
help to ensure the pump head is installed properly.
When pushing the pump head on be sure to see the
clip is fully covering the notch as seen in the first
picture. If the tab is not fully engaged, there is a
possibility of it popping off the pump head as seen in
the second picture.
Operation
Programming the Dispenser - Reset timer before programming.
Note: If a mistake is made during the programming, simply push the
reset button and start over.
A.
12 Hour or 24 Hour (Military) Mode
Hold the “Clock” button down for 5 seconds or more to change back &
forth to between the 12 & 24 hour modes.
B.
Set the Time and Day
When the unit arrives the display may be blank or may display a time. Plug the
unit into an outlet before programming.
NOTE: Make sure that the bar in the bottom of the display is over the word
OFF – if it isn’t, press the MANUAL button until it is.
1.
To set the time and day of the week, hold the CLOCK button in and press the day, hour, and minute buttons
until the proper day, hour, and minute is achieved.
Note: The days will be across the top of the screen and will advance as the button is hit. The time
must be set to AM and PM it is in the left top corner of the display. By holding in the Day, Hour, or
Minute button for three seconds the setting will continue to advance until the button is released.
