DEMA MODEL 607-3, 607-3DF & 607-3SS
HI-FLOW FILL STATION
INSTALLATION INSTRUCTIONS
I-935
Pg. 1 of 3
Rev. A-35120 12/01/09
I.
PARTS:
PARTS CHECKLIST
ITEM
PART NUMBER
DESCRIPTION
607-3
607-3DF
607-3SS
A.
607-3, 607-3DF or 607-3SS
Fill Station Assembly
1
1
1
B.
60-47
Outlet Tubing 10’ long
1
1
1
C.
76-2-13
Hose Clamp
1
1
1
D.
100-16E-4
Tubing & Foot Valve Assembly
1
2
1
E.
61-107
Ceramic Weight
1
2
1
F.
66-54
#10 Screw & Anchor Kit
1
1
1
G.
61-9K
Metering Tip Kit
1
1
1
H.
60-52
Wire Hose Hanger
1
1
1
II.
PURPOSE:
The only difference between the 607-3 and the 607-3DF is that the
607-3
is a
single product
unit whereas the
607-
3DF
is a
two product unit
(the DF stands for DUAL FEED).
III. INSTALLATION:
CAUTION: ALL WORK DONE SHOULD ADHERE TO ALL APPLICABLE PLUMBING CODES.
1. Hold assembly to wall, locate positions of mounting screws. Drill holes in wall about 1” deep. Mount
assembly to wall using screws and anchors provided.
2. Install priming ring in outlet tubing (large diameter), a few inches from one end. Slip tubing over threads of
injector, with priming ring close to the injector. Secure with tubing clamp and cut to convenient length.
3. Attach water supply hose (not provided) to water inlet and tighten.
4. To install wire hose hanger, slip outlet tubing through hose hanger.
IV. CHEMICAL ADJUSTMENT:
CAUTION: Be careful when working with hazardous chemicals.
1. Select metering tip using Table 1 as a guide. Screw tip into inlet barb of injector.
2. Cut inlet tube to convenient length, at least 18” long to insure priming but not more than 6’ (greater lifts reduce
injection capacity).
3. Slip ceramic weight over tubing and insert end with foot strainer into chemical. Attach other end to inlet barb
of injector.
Table 1: Induction readings taken at 50-psi
inlet pressure & 9 GPM.
METERING TIPS
1 CPS
COLOR
OZ/GAL
RATIO
Clear
0.21
606.3 – 1
Purple
0.26
496.9 – 1
Yellow
0.44
288.6 – 1
Green
0.83
155.0 – 1
Pink
0.95
134.1 – 1
Turquoise
1.57
81.6 – 1
Black
2.01
63.6 – 1
Gray
2.64
48.4 – 1
Red
3.40
37.7 – 1
Blue
4.11
31.1 – 1
Brown
5.64
22.7 – 1
White
7.19
17.8 – 1
Orange
8.71
14.7 – 1
None
14.88
8.6 – 1
Induction rates may vary from product to product,
NOTE: IN ORDER FOR UNIT
TO OPERATE PROPERLY,
FLOW RATE NEEDS TO BE 10
GPM OR GREATER.
