I-1031
Page 3 of 3
Rev. -- 5/31/11
screw clockwise until it stops to use the chart below and the number of turns from closed to determine the
amount of product needed. No noticeable adjustment will occur past four turns out. Seven full turns out will
completely loosen the screw. The chart below is for reference only.
Bypass @ 20 PSI
Bypass @ 30 PSI
Bypass @ 40 PSI
Bypass @ 50 PSI
Approx. bypass
water at all settings
.93 GPM
1.19 GPM
1.38 GPM
1.51 GPM
# of Turns
from Closed
Oz/min @
20 PSI
Oz/min @
30 PSI
Oz/min @
40 PSI
Oz/min @
50 PSI
1
turn 3.7 4.3 4.9 6.1
2
turns 6.1 7.4 8.6 9.2
3
turns 29.4 38.4 44.8 48.6
4
turns 62.7 75.3 92.2 99.8
Note:
The numbers listed are only the water that passes through the spray arm.
This does not include the bypass water.
Troubleshooting
Symptom Probable
Cause
Remedy
Too much product is getting
into the container/Too little
product is getting into the
container.
1.
Set screw not set properly
2.
Bypass clogged or not working
1.
Check to make sure the set screw is in the unit and
is tightened down properly using the table above.
2.
Look at the tubing to see if any clogs appear,
watch the outlet tubing to be sure water is coming
out of it. Remove clog if found.
Warranty
Merchandise Returns
No Merchandise will be Returned for Credit Without DEMA’S Written Permission. Returned
Merchandise Authorization Number is Required in Advance of Return.
Product Warranty
DEMA products are warranted against defective material and workmanship under normal use and service
for one year from the date of manufacture. This limited warranty does not apply to any products that have
a normal life shorter than one year or failure and damage caused by chemicals, corrosion, physical abuse,
or misapplication. Rubber and synthetic rubber parts such as “O”-rings, diaphragms, PVC tubing, and
gaskets are considered expendable and are not covered under warranty. This warranty is extended only to
the original buyer of DEMA products. If products are altered or repaired without prior approval of DEMA,
this warranty is void.
Defective units or parts should be returned to the factory with transportation prepaid. If inspection shows
them to be defective, they will be repaired or replaced without charge, F.O.B. factory. DEMA assumes no
liability for damages. Return merchandise authorization number must be granted in advance of returned
units for repair or replacement (See “Merchandise Returns” above).
