7
Safety Release Valve Operation:
1) If you lose power use the safety valve to descend the Jack Ram
2) Remove the dustproof plug to expose the hex screw.
3) With the supplied hex wrench, loosen the hex screw until the jack starts to
descend.
4) Once descended remove from under vehicle.
5) Then tighten the hex screw and replace the dustproof plug.
Adjusting Screw Operation:
1) Once the jack is placed under the vehicle in the correct position the
adjusting screw on top the ram can be un-screwed so that the pressure
ram does not have to travel as far to lift the vehicle.
8
12V Power Adapter with Quick Disconnect
1) Use the supplied 12V power adapter to supply power to the jack.
2) If the red LED is not illuminated on the power adapter check the fuse by
simply unscrewing the metal cap located on the end of the power adapter.
3) If the fuse is bad replace with one that was supplied with the jack.
4)
Also check the vehicles power outlet fuse.
Electric Jack Operation
1) Before operating the jack, read and understand all the important safety
instructions and warnings contained in the front of this manual.
2) Also refer to any vehicle owner’s guide before lifting any vehicle.
3) Connect the power adapter to the vehicles 12 volt power outlet.
4) Connect the two pin plug to the quick disconnect connector on the jack.
5) Once the jack is placed under the vehicle in the correct position the
adjusting screw on top the ram can be un-screwed so that the pressure
ram does not have to travel as far to lift the vehicle.
6) Press the Jack Ram switch upwards to active the Ram upwards.
7) Press the Jack Ram switch down to activate the Ram downwards.
8) Once the Ram has reached it’s desired or maximum height return the Jack
Ram switch to its CENTER position.
9) Once down, turn the switch to the CENTER position to turn the Jack Ram
Off.
