FEATURES
1.
POWER/PLAY switch
– Turns power on or off.
2.
INPUT jack
– Plug your guitar cable into this ¼” jack.
3.
OUTPUT Jack
– Plug a ¼” cable from this jack to your amp.
4.
DISPLAY
– Shows note, calibration adjustments, metronome, rhythm style, and tuning meter.
5.
CALIB/TEMPO buttons
– Adjusts tuner calibration & tempo up or down.
6.
MODE/BEAT buttons
– Switches from tuner to metronome & adjusts beats per minute.
7.
NOTE/RHYTHM buttons
– Adjusts pitch & rhythm styles.
8.
INTERNAL MIC
– Picks up acoustic sound from instrument (for tuning).
9.
SPEAKER
– Produces the audible tuning pitch.
10.
TUNING GUIDE LEDs
– Provides visual tuning guidance for sharp, flat, and “in tune.”
11.
TILT STAND
– Provides a tilt-up angle for easy display reading.
TUNING IN SOUND MODE
1. Press the power/play button to turn the
CTM-40 on.
2. Press the note button.
3. The reference pitch will be heard through
the speaker.
4. Press the note button again to select
the appropriate pitch. The note name will
appear on the display.
5. Tune instrument to match the
reference tone.
TUNING IN METER MODE
1. Press the power/play button to turn the
CTM-40 on. The CTM-40 will automatically
turn off when the tuner is not in use for
20 minutes.
2. If you are using an instrument with a pickup
or contact mic, plug your instrument into
the input jack. If you wish to tune your
instrument using the built-in mic, do not
connect a plug to the input jack.
While tuning with the onboard mic, a
quiet environment is recommended for
precise tuning.
Note:
If a plug is connected to the input
jack, the built-in mic is disabled. The input
jack is for mono use only.
Stereo plugs
cannot be used.
3. When the power is turned on, the reference
pitch defaults to A = 440 Hz . If you wish
to change the reference pitch (calibration),
press CALIB
or
. This can be adjusted in
1 Hz steps over a range of 430Hz -- 450 Hz.
4. Play a single note on your instrument. The
name of the nearest note will be displayed.
5. Adjust the tuning of your instrument so that
the meter moves to the 0 position (center)
and the center (green) pitch guide LED is
lit. The left indicator of the tuning guide will
light if your instrument is flat, and the right
indicator will light if your instrument is sharp.
1
6
8
9
10
2
4
5
SPECIFICATIONS
7
11
3
Input Impedance:
680k Ohms
Indicator:
LCD Display
Connectors:
1/4” (6.3mm) Input and Output Jacks
Power Supply:
3 Volt (2 x AAA)
Power Consumption:
3mA (Metronome), 8mA (Tuner)
Expected Battery Life:
100 Hours Continuous Input
(depending on use)
Accessories:
Owner’s Manual
Dimensions:
4.01”(102mm) Wide x 2.44”(62mm)
Deep x 0.55”(14mm) High
Weight:
2.54 oz (72g) (Including the batteries)
