25
GB
Trouble Shooting
Problem
Possible cause
Fault correction
Device does not
start
Mains voltage not on
Check plug socket, cable, line and
plug, where appropriate, have
repaired through electrical specialist
On/Off switch
( 3)
defective
Repair by Service Centre
Worn carbon brushes
Defective motor
Device runs with
interruptions
Power cable is damaged
Check the cable and have it changed
by the Service Centre if necessary
Internal loose electrical
connection
Repair by Service Centre
On/Off switch
( 3)
defective
Blades ( 8)
become hot
Blades ( 8) are blunt
Have the blades ( 8) sharpened or
replaced (Service Centre)
Blades ( 8) are notched
Have the blades ( 8) checked or
replaced (Service Centre)
Too much friction due to lack
of lubrication
Oil the blades ( 8)
Noise and vibration values have been de-
termined according to the standards and
regulations mentioned in the declaration
of conformity.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning
:
The vibration emission value may
differ during actual use of the
power tool from the stated value
depending on the manner in which
the power tool is used.
Safety precautions aimed at pro-
tecting the user should be based
on estimated exposure under
actual usage conditions (all parts
of the operating cycle are to be
considered, including, for example,
times during which the power tool is
turned off and times when the tool
is turned on but is running idle).
