Delta VFD-ED Series, User Manual

Page: 109 / 389

Ch07 Option Cards | VFD-ED
7-4
7-1 EMED-PGABD-1*, EMED-PGABD-2
Applicable encoder: A/B/Z & U/V/W Absolute Encoders
unit: mm [inch]
15.5 [0.61]<2X>
47.0 [1.85]<2X>
53.0 [2.09]
19.
0
[0.
75]
30.
0
[1.
18]
10
5.
0
[4
.1
3]
<
2X>
10
9
.0
[4
.2
9
]
2
1.9
[0
.8
6]
Ø
4.0
[Ø
0.1
6]<
3X
>
Ø3
.5
[Ø0
.14
]
Dimension
Diagram
* EMED-PGABD-1 is to be phased out in the first
quarter of year 2021, and will be pin-to-pin
replaced by EMED-PGABD-2 after EOL.
Wire Gauge Torque
30–16 AWG 1.6 kg-cm [1.4 Ib-in.]
The following table lists the terminal specifications.
Terminals Descriptions
TB2
Vin
Voltage input, to adjust the amplitude of output voltage at terminal A/O and
terminal B/O. It also provides a 5 V voltage to support line driver’s signal.
Vin voltage range: 8–24 V, Max: 24 V.
A/O, B/O
Output signal for the push-pull voltage frequency division.
Default: Output amplitude is about +24 V. Use SW3 to disable the internal
default power. Required input power through Vin-GND port (i.e. output voltage’s
amplitude)
Vin voltage range: 8–24 V, Max: 24 V.
Push-Pull Voltage Output
Max. output frequency: 100 kHz
Supports frequency division output, the frequency division range: 1–31.
GND Common ground terminal connecting to the host controller and the motor drive.
AO, /AO, BO, /BO
Output signal for the line driver frequency division.
Line Driver RS422